We can make that with ice, water, that gives to your material. The extraction bags are the most efficient, polyvalent way to make your own theme, of very high quality. The bags can be used in dry conditions, like a basic filter, that you shake above a recipient, the trichomes fall with the weight, passing on the polinator. The two bags should hang exactly one below the other. Adjust both bags on the edge of the cube, using built-cords.

 

Instructions for use:

 

-Place the fine mesh bag in a bucket.

-Place the coarse mesh bag inside the fine mesh, leaving a space of about 8cm between the two meshes.

-Fill the bucket up to 15 cm from the edge with cold water, remove air that has been able to stay among the bags.

-Place a layer of ice on top of this, a layer of plant material, repeat the operation ending with a layer of ice.

-The bucket should be filled to 5cm from the edge, if necessary add more water or ice. Let stand 15 minutes.

-Use a whisk to beat with rods, to stir the mixture for 15 minutes at slow speed.

-Remove the whisk, stir the bucket and wait until all the material sit in the background. Repeat this step 4 times.

-Remove the coarse mesh bag and squeeze to drain the water.

-Squeeze the bag to remove water completely.

-Remove the bag of fine mesh, allowing water to drain, the resin glands are retained within the mesh.

-Take the mass of resin glands Secret-Icer, screened on a plate with a spoon and a strainer, once the process, change the material to a dry dish. Let stand for 12 hours and re-sift the glands.

-Repeat the above process 12 hours later and let dry another 24 hours. 

 

Council for the maintenance of the net: It is recommended to purge the vegetable matter or other branches that may damage the mesh. After several uses, finer meshes can be closed off, it should be cleaned with alcohol.